Trim Overview

	Size	Pieces / Carton	Design	Wall&Ceiling Board	SlatWall	RibCore
J Trim (*3/4" Grey Special Order)	10'	50
Inside Cove Corner	10'	25
H Channel Snap-In Kit	10'	20
Outside Corner	10'	25 or 50
Outside Corner Rounded (*Special Order)	10'	15
F Trim (*Grey Special Order)	10'	50
Base Trim	10'	50
45° H Channel (*Grey Special Order)	10'	25
SlatWall Top Cap	8'	50

Snap-In Trims

The newest addition to the Trusscore trim lineup.

Trusscore’s Snap-in trims are the latest evolution in our products. Designed to offer a quicker, easier, and more accurate installation experience, we’re confident that installers will love the improvements they bring to their job site.

• Superior installation experience
• Install trims 2 times faster
• Easily determine accurate installation position of trim on the wall
• Easily ensure proper expansion and contraction spacing between trim and board
• Quickly review and inspect board spacing by detaching the cap after project completion
• Durable design that will last

H Channel and U Channel

Components Assembled

Installation​

INSTALL ORDER
When installing walls, the following trims should be installed before the panels:

• Bottom of wall – J Trim or Base Trim
• Top of Wall – J Trim or Inside Cove Corner
• Perimeter of doors and windows – J Trim

Note: Large & Small Outside Corners must be installed after your Wall&CeilingBoard, SlatWall or RibCore panels are installed

FASTENERS
Wood – #10 x 1-1/4” Truss or Pancake Head screws
Concrete – 3/16” x 1-1/4” Flathead screw (Tapcon)

Use only corrosion-resistant (galvanized, stainless steel or aluminum) screws with a minimum head diameter of 3/8”. The recommended fastener length is 1-1/4” for wood studs or masonry, 1-1/2” or 2” for drywall installation, and 2-1/2” if furring strips are used for strapping.

Note: Large & Small Outside Corners are the exception. They are installed with silicone caulk adhesive to avoid visible fasteners.

CUTTING
Tin snips are the safest and easiest tool to use when cutting trims. For a cleaner cut, avoid closing the blades at the end of a stroke.

SPACING
It is essential that a minimum of 1/4” clearance is left at the ends of all panels and trims to allow for expansion and contraction.

WET APPLICATIONS (Carwash, Etc.)
Base trim should be used at the bottom of walls in wet applications. Alternatively, J Trim can be used if ¼” diameter holes are drilled every 16” in the bottom of the trim for drainage.